Recent content by DavidTodo

I'd you'd like to see what type of wheel and tire combination you might be able to fit, check out fitment industries' gallery for and filter on the Corolla https://www.fitmentindustries.com/wheel-offset-gallery?make=Toyota&model=Corolla&order=year&page=1

I will let you know in a couple weeks, I'm putting konig hypergram and 245/40 r18 tires on it, I paid for them, i just have to find time to get them put on, I've got coilovers though, so clearances may be a bit different

Nice, I like those wheels

I would have to hit a pretty deep pot hole or an insanely large speed bump, I can still run through automatic car washes, and there was only 1 time I scraped the front end, and that's because I was leaving the parking lot like an idiot. The handling and cornering is much improved, especially...

Here it is after the godspeed mono ss coilovers

Toe, they can adjust toe

I actually just went to an NTB this morning to get an alignment this morning after lowering my car more, they can adjust to and that's about it. Luckily I measured very carefully when making my adjustments and my camber and caster are at the same points. -2.5 degrees of camber, I don't remember...

Nice job, I just dropped mine a bit more this weekend too, 24.75" all around with godspeed mono ss coilovers, crazy thing is, I still have an inch more that I can drop it. How do you like there hight and ride? I'll have to take some pictures and post them

You may be able to fabricate a mount for a centrifical super charger, it may be a tight fit though

Turbokits.com sells a, wel, turbo kit for our engine, I think it's fairly priced, I've seen a lot of people running it. I plan on installing it this spring, however I have a CVT. So we'll see if my transmission will handle the power. I know for a fact the 6 speed can handle it fine

I'm going to get some konig hypergram wheels 18x8.5 38mm offset with tires at 245/40. I anticipate having to roll and or pull my fenders, I can keep you posted.

If you haven't already, use a wheel offset calculator to make sure you get the fitment you're looking for, that low offset sounds like it's going to poke out of the fender. If that's the look you're going for then your ok. I dropped my 2015 s about 2 inches all around. But I'm on stock...