Recent content by cdenton9

STOP! Before your the next car fire on the highway!!! You need proper wiring! #12 awg is only good for 20amps, max. Usually at 80%, gives you 18amps. Your gonna need at least #8awg automotive grade wire for your amplifier. Also depends on the specs for the amplifier. You need to properly fuse...

You won't need the remote turn on if your amp will accept signal sensing. When I was using it on mine, the reception on the radio got really bad. Amp would cut on and off cause it was trying to switch between the two. I am now using that remote turn on wire for a new mirror that I got. Has...

http://auerautomotive.com/led-fog-lights/corolla-led-fog-lights-2014-2015/ I'm curious about models that do not have fog lights. On the signal / light lever, is there a position for fog lights? If not, then it's probably not pre wired. I had fog lights but it drove me nuts that they weren't...

http://auerautomotive.com/corolla/led-fog-light-upgrades/led-fog-light-upgrade-2014/

I changed out the entire fog light assembly with ones from auerautomotive.com Same company that Toyota / Lexus already use. Has 3 year warranty and the look awesome! Took 10 minutes to change out both of them! And they are white.

Has anyone installed any of the Ultra Racing "safety" bars? I bought the two that go on the rear axel. The one closest to the muffler fits fine. But I'm not sure how well the other one will fit. The mounting points are straight whereas the pivot arms on the axel are angled. What about other UR...

mine works but it sucks. sound quality is horrible. you can squeeze your hand to it from the passenger side and push it out, then check the connections.

Has anyone purchased and installed the Ultra Racing UR-RL2-446 bar that mounts to the inner rear axel? I'm concerned about the fit not being correct. The bar ends are straight whereas the axel connecting points are angled. (Hope that makes sense)

Are you sure your amp didn't die? You said it worked at first, so you might have had it wired up correctly. Take it to a Best Buy or stereo shop and have it bench tested. If you go to the installation bay, they'll probably do it for free. Anyways, it doesn't matter where you tap the speakers...

Connects to back of radio: http://www.uneeksupply.com/2014-Toyota-Corolla-Factory-Radio-Wire-Harness_p_41342.html Connects to cars wiring harness: http://www.uneeksupply.com/2014-Toyota-Corolla-Wire-Harness-for-radio-replacement_p_41343.html These are the adapters that I used to add amps to my...

I bought the wiring harnesses that go between the factory HU and the cars wiring harness, to make my connections to. Tip: I've never removed the factory stereo, you can access the wiring through the glove box. It takes patience though. I have the 2016 Kicker VcompR loaded enclosure and the...

I agree with statement above. I used the speaker outputs off the stock HU and hooked up the RCA adapters from Kicker. Sent high level signal out to Kenwood 4 channel used splitters on the rear channel and sent that to the Kicker amp and sub. I guess my amplifiers provide enough resistance to...

That amp uses both turn on methods. I had this problem with my Kenwood 4 channel and my Kicker mono. I removed the amp turn on wire and just rely on the the high level input from the speakers. Problem solved for me. Try using only one or the other. Also, I just tapped the speakers, the Kicker...

http://toyotaparts.sparkstoyota.com/displayparts.php?Mdl_dtl=955&Part_cat=11&parts_id=5192 They have a lot of other goodies too! I don't know about the dealership cost to install, probably through to roof! I do everything myself with Toyota pdf's.