Recent content by Ua22plumber

So looking around I assume the transmission mount is the mount on top of the transmission? And I want to unbolt the mount from the car to allow the transmission to move up? I asked the shop if they would install the parts I bought and they said no.

So I guess I just have to find the transmission mounts now. The shop fixed the studs they cross threaded yesterday. So now I can do the passenger side lower control arm. That side looked like all the bolts had enought clearance to be removed. Any suggestions on removing and replacing them? Do...

Is there no one that has attempted this before? Is the transmission not attached to the engine? Would I not have to raise the whole engine?

i have a 2004 Corolla and have been told by a mechanic that I need to replace my lower control arms because the bushings are dry rotted. I had to buy 2 brand new front tires because the tread was cupped. They believed this was part of the cause I have also heard clunking from the front end as...

ok i got the 02 sensor. there is only one upstream sensor, correct? and one down stream sensor. and its between the engine and the fire wall under a heat shield? I just wanted to mack sure because auto zone.com had a diagram and it showed more than that but I think it was for a v6 or some...

when I google that code the were so many post about people changing the O2 sensor and it was not actually the problem... I don't want to waste $90 on something that isn't broke... I think a saw something about the intake gasket causing problem and needing to be replaced. any thought? thats...

Just pulled a check engine code of P0133 Oxygen Sensor Circuit Slow Response (Bank1, Sensor1)

The plugs where changed out at 96000 miles.

This is my wife's 2004 corolla which I rarely drive. I drove it today and after driving for three miles I came to a stop sign and while sitting at the stop I thought the engine was going to die, but it did not. That's when my wife says to me "oh ya it's been doing that for a while when it's...