Search results

Well for this you need to remove the tires from the rims. When the tries came with the Tube then you can do that. Now as the tires are coming tube-less than this practice is not recommended as by removing and installing tires may damage the wall edge and it is also not good for the rims.

This is definitely valves/tappet cover gasket. Its cheap to change it.

Check the manual and use only the oil which is recommended in the manual. Using other oils may decrease the life of the transmission as well as problem in shifting.

If your tires are uni-directional then just put the front on the back on the same side. If they are bi-directional then put the front on back on the same side but put the back on the front opposite side. Hope it helps.

hit the "electric starter" with small spanner for 10~12 times. The starter may stuck with the fly wheel or may be the coil which push forward the starter is not working.

Corolla 2010 comes with the clutchless design. The Compressor has axial pistons and the stroke of the piston is controlled by Swash plate. There is a solenoid which can control the swash plate angle. If this solenoid goes out of order you need to replace complete compressor. There is no repair...

Dont take the risk and replace the water pump if your car has high miles. The leak could increase anytime which can overheat your car and damage your engine.

LOL @ Someone :p

Thanks man. Yes the mechanic identified pretty quickly.

ok Clean it with carburetor cleaner and be careful. Use soft cloth and do not use tools to clean, as they may put scratches or may be damage the throttle body.

Guys problem solved, it not the stabilizer bar. Its the mud shield which was making the strange sound :)

Have to try to clean your throttle body?

I bought the expansion valve for my car but never installed as the mechanic said that my valve is ok.

Ok Then your compressor is gone. Replace the compressor.

Hello Guys, I just changed my shock absorbers and after that I noticed a sound like a metal is hitting another metal. I check and found that stabilizer bar is hitting into the chassis as shown in the pictures attached. Could you let me cure for this? Regards Ali Khan

Then Check your compressor fuse first

Check the gas pressure and you will get to know that you have gas or no.

Make sure that they dont press too much. it should only be pressed enough that there should be no play and thats it.

It seems that the bearings job is not done properly. When you go on curve the thrust force on the bearing increased and the noise go away.